H o w  t o  c o n v e r t   y o u r  n u m b e r  t o  t e n  d i g i t  d i a l i n g

Windows 98

1. Find the "My Computer" Icon on your desktop and open it.
2. Double Click the Dial-Up Networking icon.
3. Double-click on the Icon in the folder for your connection to BrandywineNet
4. Click on the "Dial Properties..." button
5. Make sure your area code is filled in the "Area Code" field
6. Click the "Area Code Rules" button
7. Check the box reading "Always dial the Area Code (10 digit dialing)
8. Close all the boxes by clicking "Ok"

Windows 95

1. Find the "My Computer" Icon on your desktop and open it.
2. Double Click the Dial-Up Networking icon.
3. Right-Click on the Icon in the folder for your connection to BrandywineNet, and select " Properties." with the Left button
4. In this dialog, uncheck the box labeled  "Use country code and area code", and add the area code in the phone number field (not the Area Code" field)
5. Click Ok, Close Dial-Up Networking, and Close My computer.

Windows 3.1

When using..

TCPMAN:

Open Tcpman and go to dialer. Then click on setup.cmd and this will ask you for the number you are dialing. Add 610 in front of the number. Continue through the setup, WITHOUT CHANGING ANYTHING ELSE, then exit out of the Tcpman and save the changes if it asks.

Windows 3.1 Microsoft Dialer:

1. Double Click on Microsoft Explorer Program Group. 
2. Double Click on the BrandywineNet Icon. 
3. Click on Properties. 
4. On the "General" screen, uncheck "use country code and area code".
5. Put '610' in front of the phone number listed. Click ok then click
6. close and SAVE THE CHANGES.

Macintosh 8.0

1. Open up the Control Panel.
2. Go to PPP settings. (PPP, Config PPP, Config PPP 2.5, ect.)
3. Change the number in this dialog to the new ten digit dial in number.

Macintosh 7.5

1. Open up the Control Panel.
2. Select PPP settings. (PPP, Config PPP, Config PPP 2.5, etc.)
3. Press "Config" Change the number listed to the ten digit dial in number.